3D Laser Mapping Ltd. are the leading LiDAR specialist in the UK and
supplier to 90% of the UK airborne LiDAR operators. Based in
Nottinghamshire, 3D Laser Mapping provide pre and post sales support
for a wide variety of LiDAR products and offer consultancy services and
training from our highly experienced technical staff.
Product Name: 2D Scanners
Product Category:
Scanners
- Hardware
The Riegl LMS-Q series 2D laser scanners provide accurate non-contact line scanning using narrow infrared laser beams. The instruments make use of the precise time-of-flight laser range measurement principle and of fast line scanning by means of a high-speed opto-mechanical scan mechanism, providing fully linear, unidirectional and parallel scan lines.
Product Name: 3D Scanning
Product Category:
Scanners
- Hardware
The combination of a high-performance laser imaging sensor and a
high-resolution digital camera provides a wealth of information which
lends itself to a broad range of applications, from 3D-modelling and
documentation, to coastal mapping, vegetation mapping, and rapid
topographic surveys.
Light Detection and Ranging (LiDAR) is an airborne mapping technique which uses a laser scanner to measure the distance between the laser sensor and the ground resulting in a surface "map". This technique can be used for a wide variety of applications including topographical surveys, coastal mapping and forestry.
The Riegl LD90-3 and LD90-4 series distancemeters are based upon the well-proven principle of time-of-flight measurement of short laser pulses. They can be operated with practically any target surface, i.e. "reflectorless" up to many hundred meters, and with reflecting foil or retroreflectors up to more than 1000 m.
LiteMapper systems are fully integrated sensor packages for highly accurate 3D laser measurements of the earth's surface.
AEROcontrol is IGI's GPS/IMU system for the precise determination of position and attitude of an airborne sensor. This can be the position of the projection center and the angles omega, phi, kappa of the aerial camera system or an airborne laser scanner.
Product Name: Laser Units
Product Category:
Scanners
- Hardware
The RIEGL LMS-Q series of laser scanners make use of the pulsed time-of-flight range measurement principle and beam scanning by means of an opto-mechanical scan mechanism, providing fully linear, unidirectional and parallel scan lines. The instruments are extremely rugged, therefore ideally suited for the installation on aircraft and are also compact and lightweight enough to be installed in small single-engine planes, helicopters or RPVs.
Product Name: LaserWin
Product Category:
GIS Software
- Software
LaserWin provides a convenient graphical interface to read the current configuration completely, to save these settings, and to change them on request. As LaserWin allows communication not only via the standard serial interface but also via a TCP/IP interface it enables remote configuration and data retrieval also via the intranet/internet.
Using the very latest laser scanning technology coupled with a high precision navigation system, 3D Laser Mapping and IGI mbH have joined forces to offer a novel 3D mapping system to scan roads, buildings and trees from a moving vehicle.
The Riegl FG21 "LASERTAPE" series are extremely compact, durable, high performance laser rangefinders. Protected by thick rubber, it is ideal for use in harsh environments. The RTS21-HA, a total station version of the FG21, allows the acquisition of profile data in inaccessible and unsafe areas.
Using the latest in digital signal processing technology, the Riegl FG21 speedmeters are small, compact and fully portable, with an approved range of 1000m.
